Zonal Infrared Thermal Beauty Blanket

ZONAL INFRARED THERMAL BEAUTY BLANKET

MOST WIDELY USE SALON BLANKET IN EUROPE & USA
3 ZONES LOW VOLTAGE FULL-ENCLOSURE INFRARED SAUNA WRAP
FIR WRAP THERMALBEAUTY BLANKET MY-2B(iii), PROFESSIONAL OR HOME SAUNA USE

The Far Infrared (FIR) Sauna Wrap MY-2B(iii) is a low-voltage FIR device, with 3 separately controlled heating zones, suitable for professional use at a spa, weight loss center or beauty salon. Sturdy and made for frequent operation. Provides a complete sauna radiat heat experience. The Infrared (FIR) Sauna Wrap is also portable and easy to clean, for travel or home use. The Direct Infrared heat from the blanket allows for gentle radiant relaxation of the muscles and controlled perspiration.

INFRARED (FIR) SAUNA WRAP MY-2B(iii) COMPOSITION AND FUNCTIONS:

Control Box:	adjusts and controls the temperature and timer settings of the blanket.
Thermal Blanket:	conducts heating to the body. Made of Nylon,with Space Carbon Fiber heating elements, covered by a layer of PU (polyurethane) fabric
Power Cord:	supplies main power to the control box.
Connection Leads (3):	mounted on the end of the blanket, connect the thermal blanket to the control box.

PANEL DISPLAY AND FUNCTIONS OF THE KEYS:

The Infrared FIR Sauna Wrap MY-2B(iii) is composed of a control box, a thermal Infrared blanket, a main power lead and 3 connection leads. The control box keeps a memory of the last settings used

ON/OFF	Switch the system 'ON' or 'OFF'
Channel Key	Select the respective body zones (1-2-3). One or more zones can be targeted in a sauna session.
Temperature Key ()	Press to increase or press to decrease the temperature, 1 °C for each time pressed.
Timer Key ( )	Press to increase or press to decrease the time, 5 minutes for each time pressed.
Overload Display	Overload indicator lights when the power surpasses 300W, and the alarm buzzer will sound.
Start/Stop Key	Press Start/Stop key to start or stop the device after setting the temperature and timer.

INFRARED (FIR) SAUNA WRAP MY-2B(iii) INSTRUCTIONS:

1.	Place the Far Infrared Sauna Wrap on a flat surface, such as the bed or floor.
2.	Wrap your body in the blanket. If a massage or body oil is used, then it is recommended to first wrap the body in a plastic film or sheet to protect the thermal blanket.
3.	Put the control box on a flat surface such as a table and insert the plug into the main power socket.
4.	Connect the 3 connection leads between the thermal blanket and the control box. Make sure that lead "1" is connected to jack "1", lead "‘2" to jack "2", etc. or the thermal blanket will not work.
5.	Turn the main power switch on at the back of the control box. The red ‘Power’ indicator on the control panel will light. The device has not started working yet.
6.	Press the "ON/OFF" key to start setting the temperature and the timer. The Channel key shows"1" (body zone 1).
7.	Press Timer to set the working time. For each time pressed, the time will increase or decrease by 5 minutes.
8.	Press Temperatureto set the working temperature. For each time pressed, the temperature will increase or decrease by 1° Centigrade. Set the temperature to your specific requirements.
9.	Then press ‘Heating Zone’ key to change the zones. Repeat steps 6, 7, and 8 to set and start body zones 2 and 3.
	Zone 1: Upper body and limbs (suggested temperature 38° C) Zone 2: Mid body (suggested temperature 44° C) Zone 3: Lower body and limbs (suggested temperature 42° C)
10.	Press "Start/Stop" key. The green indicator will light, showing that heating has started.
11.	When the heating timer counts down to "‘0", a signal will sound three times and the digital timer will display "0" showing the heating has finished.
12.	After using, pull the plug out from the power source.
13.	If at any time you need to stop the session, just press the ‘Start/Stop’ key. When the green indicator goes off, the system has stopped working.
14.	Wipe the sweat from the surface of the thermal blanket with a wet towel and dry it by laying it flat on a bed or table for more than 1 hour.
15.	Fold the blanket and store it in a dry and cool place.
16.	For professional use at spa, weight loss center or beauty salon, wipe surface of the thermal blanket as above, and leave an interval between customer sessions of at least 1/2 hour, preferably 1 hour.
SUGGESTED USE:
1.	When the room temperature is lower than 20°C you may preheat the blanket for 10 minutes prior to use.
2.	It is suggested that you be well hydrated by drinking a glass of water prior to using.

INFRARED SAUNA WRAP MY-2B(iii) TECHNICAL SPECIFICATIONS:

Mode No.	MY-2B(iii)
Input Volts	100V ~120V 60Hz / 220V ~240V 50Hz
Output Volts	DC36V
Input Power	300W
Materials	Made of Nylon, covered by a layer of PU (polyurethane) fabric, with heating elements of Space Carbon Fiber
Control Panel	Manual Control
Heating Zones	3
Temperature	30°C ~ 60 °C / 86°F~140°F
Separate Heating Zone Controls	YES
Timer	0~95 minutes
Size	187 x 92 cm / 72" x36 1/4"
Net Weight	8.3kg
Warranty	1 year